Stage 2.5 At this stage you want to seal the base coat, I use a gloss varnish. Then apply the AK Interactive solution using an airbrush at about 10 - 15 psi. Cover the whole model with this.
Stage 3 Paint you top colour, in this case yellow for the Imperial Fists.
Stage 4 Using a stiff( ish) drybrush wet the area you want to chip, let it soak for a few seconds then start to gently rub the area...
Hope this helps. Mat.
Dwarfs Undead Crimson Fists Imperial Guard And introducing Imperial Fists P.S Squats when I get round to them.
Well I tried out the heavy chipping fluid from AK yesterday. The results are awesome definitely going to use this stuff again on a variety of projects. Will try and get some photos up later
Yes I have, the results weren't as consistent as the AK Interactive stuff (or anywhere near as good). I reckon you would need at least two pots of AK as long as you where selective where you applied the chipping fluid...
Dwarfs Undead Crimson Fists Imperial Guard And introducing Imperial Fists P.S Squats when I get round to them.